Sony Ericsson GR47/GR48 - Manual (Page 71)

14. USING THE DEVELOPER’S KIT
71
LZT 123 7589 R1A
14. Using the Developer’s Kit
This section provides you with the information needed to setup and use the
developer’s kit. Before changing switch and jumper settings, refer to “14.3
Jumpers”, page 74.
Front and rear views of the developer’s kit are shown below. Use a flat blade
screwdriver to unhinge the side clips of the kit and lift the plastic lid off to
access the inside.
Figure 14.1 Front view
Figure 14.2 Rear view
EXT VCC
RF