Bostitch CAP1512-OF - Manual (Page 8)

OPERATION INSTRUCTIONS
Pre-Start Procedures:
1. Inspect the compressor for any damaged components. Do not operate if compressor is
damaged.
2. Verify that the tanks have been drained and are clear of any moisture or dirt (See
“Draining Tank”).
Start-Up Procedures:
1. Verify that the On/Off switch is in the Off position.
2. Verify that the tank air pressure is at 0 PSI.
3. Attach the air hose to the discharge line.
4. Plug the unit into a properly grounded outlet.
5. Push the On/Off switch to On. The On/Off switch will light-up to indicate the compressor is
on. The compressor will automatically cycle on and off to keep the tank pressure
maintained .
6. Adjust the pressure regulator to the proper pressure setting required for the air tool.
Shut-Off Procedures:
1. Push in the On/Off switch to the Off position.
GENERAL MAINTENANCE
Service and Maintenance:
Prior to performing service and maintenance to the compressor, always disconnect all
accessories and attachments from the unit, and disconnect the compressor from the
electrical source and drain tank. When replacing parts, only use Genuine BOSTITCH
replacement parts.
Notice!: This compressor is equipped with an oil-free pump. There is no oil to replace or
check.
Draining Tank - Ball-Style Drain Valves:
1. Verify that the compressor is turned “Off”.
2. Holding the handle, tilt the compressor toward the drain valve so it is positioned
at the bottom of the tank.
3. Turn the drain valve to open.
4. Keep the compressor tilted until all moisture has been removed.
ANY OTHER SERVICE SHOULD ONLY BE PERFORMED BY AN AUTHORIZED
BOSTITCH SERVICE CENTER
8