Standard Horizon HX370S - Manual (Page 23)

HX370S Page 21
5.8 PROGRAMMABLE PRIORITY SCAN
The priority scanning feature allows the radio to scan while also keeping
watch on a particularly important “priority channel.” The following channels
can be set as the priority channel: 16, 09, and Preset Channels 1 through 8
(Preset Channels are described in section 5.14).
1. To set the priority channel, hold down the 16/9 key and press the MEM
key. The channel will change from 16 to 09 to Preset 1 to Preset 2 to
Preset 3 to Preset 4 to Preset 5 to Preset 6 to Preset 7 to Preset 8 with
each press of the MEM key. The displayed channel will be set as the
priority channel when the 16/9 key is released.
2. For priority scanning, hold down the SCAN key during normal scanning.
Scanning will proceed between the memorized channels and the priority
channel. The priority channel will be scanned after each programmed
channel. “P” is shown on the left side of the channel number during pri-
ority scanning.
3. As an example of priority scanning, let us say that channels 06, 07, and
08 are memorized in the transceiver’s scan memory. Priority scanning
will proceed in the following sequence:
[CH06] [Priority Channel] [CH07] [Priority Channel]
[CH08] [Priority Channel] [CH06] [Priority Channel] ……
4. Even when the transceiver stops and listens to the signal of a programmed
channel, the transceiver will “dual watch” between this channel and the
priority channel. Therefore, your priority watching of the designated chan-
nel is not compromised when the scanner has paused on an active channel.
5.9 DUAL WATCH
The Dual Watch feature allows the radio to watch for a transmission on the
priority channel and another selected Marine channel until a signal is re-
ceived. The priority channel is determined per the discussion in section 5.8
“PROGRAMMABLE PRIORITY SCAN” as described previously.
1. To start the Dual Watch feature, select a channel to be dual watched
with the priority channel and press and hold in the
SCAN key. The radio checks the priority channel for
voice traffic every one second. A small “DW” icon
will be shown blinking on the left of the display dur-
ing scanning.
2. To cancel the Dual Watch feature, press the SCAN key.