Standard Horizon HX370S - Manual (Page 32)

HX370S Page 30
5.19 CLONING
The HX370S includes a convenient “Clone” feature, which allows the memory
and configuration data from one transceiver to be transferred to another
HX370S.
1. Turn both radios off.
2. Connect the (optional) CT-32 Clone Cable between the MIC/SP jacks of
the two transceivers.
3. Hold down the PRESET key and then turn on the
transceiver. Do this for both transceivers (the order
of switching the radios on does not matter); “CLn”
will appear on the display on both transceivers.
4. On the Destination transceiver, press the PRESET
key (“Cr” will appear on the LCD).
5. Press the 16/9 key on the Source transceiver; “CS”
will appear on the Source radio, and the data will
now be transferred.
6. If there is a problem during the cloning process, “CEr”
will displayed. Check your cable connections and
battery voltage, and try again.
7. If the data transfer is successful, the Destination transceiver will return
to normal operation; Turn both transceivers off and disconnect the Clone
cable. You can then turn the transceivers back on, and begin normal
operation.