Sony CDP-CX225 - Manual (Page 13)

Playing CDs Getting Started
13
Playing CDs
You can directly select a disc for 1 DISC Shuffle Play
See “Selecting a disc directly using the remote” on page 10.
You can go to the next disc during 1 DISC Shuffle Play
Press DISC SKIP +.
You can specify the next disc to play during 1 DISC
Shuffle Play
Turn the JOG dial to specify the next disc. After all the
tracks on the current disc are played in random order,
the next disc starts playing. If you want to skip to the
next disc right away, press ENTER while playing the
current disc.
Note
You cannot specify the next disc to play during ALL DISCS
Shuffle Play.
2
Turn the JOG dial until the disc number you want
appears in the display.
1 8 2 3 4 5 6 7
DISC TRACK
STEP
PROGRAM CD 1
20 AL
1
Disc number
3 To program a whole disc, skip this step. Press
≠/± until the track number you want
appears in the display.
4
Press ENTER or PROGRAM.
5
To program other discs/tracks, do the following:
To program
All tracks of another disc(s)
Other tracks on the same disc
Other tracks on other discs
6
Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
The program remains even after Program Play ends
When you press ·, you can play the same program
again.
When you press PROGRAM during Continuous or
Shuffle Play
The program will be played after the current track.
The program remains until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
Repeat Steps
2 and 4
3 and 4
2 to 4
The disc being
programmed Playing order
The track being programmed
1 8 2 3 4 5 6 7
DISC TRACK
STEP
PROGRAM CD 1
20 1 1
Track number
1 8 2 3 4 5 6 7
DISC TRACK STEP
PROGRAM CD 1
20 1
1
Creating Your Own Program
(Program Play)
You can arrange the order of the tracks and/or discs to
create your own program and the program is stored
automatically. A program can contain up to 32 “steps”
— one “step” may contain a track or a whole disc.
You can make a program using the controls on the
remote as well as the ones on the player. However, the
programming procedures are different.
Creating a program on the player
1
Press PROGRAM.
If a program is already stored, the last step of the
program appears in the display. When you want to
erase the whole program, hold down CLEAR until
“All Clr” appears in the display (see page 14).
JOG ENTER PROGRAM
·
≠/±
CLEAR CHECK
POWER