Sony CDP-CX225 - Manual (Page 9)

9
Basic Operations
Basic Operations Basic Operations
5 Press ENTER to start playing.
The selected disc is set to the playing position, and the player
plays all the discs from the selected one (ALL DISCS) or all the
tracks once (1 DISC).
Adjust the volume on the amplifier.
Display information while playing a disc
While playing a disc, the display shows the current disc number, track
number, playing time of the track and the next disc number.
To stop playback
Press p.
Current disc number
Current track number Playing time of the track
Next disc number
1 8 2 3 4 5 6 7 ALL DISC S
DISC TRACK
MIN SEC
NEXT DISC
CD 1
20 1 57
0 2 8
When you turn off the player
by pressing the POWER
switch (standby mode)
The player remembers the
last playing disc and the
play mode (Continuous,
Shuffle (see page 12) or
Program (see page 13)).
When you turn on the
player again, therefore, the
player plays the same disc in
the same play mode. Note
that the player does not
remember this information,
if you turn off the player by
pressing the power switch of
the amplifier or receiver
while the AC power cord is
connected to the switched
AC outlet of the amplifier or
receiver.
To
Pause
Resume playing after pause
Go to the next disc
Go back to the preceding disc
Go to the next track
Go back to the preceding track
Stop playing and remove the disc
Press
P
P or ·
DISC SKIP + once.
Hold down the button to skip discs.
DISC SKIP – once.
Hold down the button to skip discs.
±
≠
OPEN and then ENTER. The disc comes
to the loading position.
OPEN ≠/±
· P
ENTER
p
CONTINUE SHUFFLE PROGRAM REPEAT
BLOCK 1 BLOCK 2 BLOCK 3 BLOCK 4
BLOCK 5 BLOCK 6 BLOCK 7 BLOCK 8 OPEN
AMS
CHECK CLEAR
ENTER
POWER