Sunrise Medical Quickie Revolution User Manual

Page 13

Advertising
background image

24

25

930354 Rev. B

930354 Rev. B

J. QUICK-RELEASE AXLES

1. Do not use this chair UNLESS you are sure that both quick-release rear axles

are locked. An unlocked axle may come off during use and cause a fall.

2. An axle is not locked until the quick-release button pops out fully.An unlocked

axle may come off during use, resulting in a fall, tip-over or loss of control and
cause severe injury to the rider or others.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

K. REAR WHEELS

A change in set-up of the rear wheels will affect the center of balance of your chair.
1. The farther you move the rear axles FORWARD, the more likely it is that

your chair will tip over backward.

2. Consult your doctor, nurse or therapist to find the best rear axle set-up for

your chair. Do not change the set-up UNLESS you are sure you are not at
risk to tip over.

3. Adjust the rear wheel locks after you make any change to the rear axles.

a. If you fail to do so, the locks may not work.
b. Make sure lock arms embed in tires at least 1/8 inch when locked.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

L. REAR WHEEL LOCKS

Rear wheel locks are NOT designed to slow or stop a moving wheelchair. Use the
only to keep the rear wheels from rolling when your chair is at a complete stop.
1. NEVER use rear wheel locks to try to slow or stop your chair when it is

moving. Doing so may cause you to veer out of control.

2. To keep the rear wheels from rolling, always set both rear wheel locks when

you transfer to or from your chair.

3. Low pressure in a rear tire may cause the wheel lock on that side to slip and

may allow the wheel to turn when you do not expect it.

4. Make sure lock arms embed in tires at least 3/8 inch when locked. If you fail

to do so, the locks may not work.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

V I I I .

W A R N I N G S :

C O M P O N E N T S & O P T I O N S

G. POSITIONING BELTS (OPTIONAL)

Use positioning belts ONLY to help support the rider’s posture. Improper use of
these belts may cause severe injury to or death of the rider.
1. Make sure the rider does not slide down in the wheelchair seat. If this occurs, the

rider may suffer chest compression or suffocate due to pressure from the belts.

2. The belts must be snug, but must not be so tight that they interfere with

breathing.You should be able to slide your open hand, flat, between the belt
and the rider.

3. A pelvic wedge or a similar device can help keep the rider from sliding down

in the seat. Consult with the rider’s doctor, nurse or therapist to find out if
the rider needs such a device.

4. Use positioning belts only with a rider who can cooperate. Make sure the

rider can easily remove the belts in an emergency.

5. NEVER Use Positioning Belts:

a. As a patient restraint. A restraint requires a doctor’s order.
b. On a rider who is comatose or agitated.
c. As a motor vehicle restraint. In an accident or sudden stop the rider may

be thrown from the chair.Wheelchair seat belts will not prevent this, and
further injury may result from the belts or straps.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

H. POWER DRIVE

Do not install a power drive on any Quickie wheelchair. If you do:
1. It will affect the center of balance of your chair and may cause a fall or tip-over.
2. It will alter the frame and void the warranty.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

I. PUSH HANDLES (OPTIONAL)

When you have a attendant, make sure that this chair has push handles.
1. Push handles provide secure points for an attendant to hold the rear of this

chair, to prevent a fall or tip-over. Make sure to use push handles when you
have an attendant.

2. Check to make sure push handle grips will not rotate or slip off.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

V I I I .

W A R N I N G S :

C O M P O N E N T S & O P T I O N S

Advertising