Sunrise Medical Quickie Revolution User Manual

Page 14

Advertising
background image

26

27

930354 Rev. B

930354 Rev. B

A. TO MOUNT & REMOVE REAR WHEELS (OPTIONAL)

Do not use this chair UNLESS you are sure both quick-release axles are locked. An unlocked

axle may come off during use and cause a fall.

I X .

C H A I R B A S I C S

Note: Axle is not locked until:

a. The quick-release button pops out

fully. (Fig. A)

b. The ball bearings are fully visible on

the outside of the sleeve. (Fig. A)

1. To Install Wheel:

a. Depress quick-release button (1) fully.

This will release tension on ball bear-
ings at other end.

b. Insert axle through hub of rear wheel.
c. Keep pressure on button (1) as you

slide axle (2) into axle sleeve (3).

d. Release button to lock axle in sleeve.

Adjust axle if it does not lock.

e. Repeat steps on other side.

2. To Remove Wheel:

a. Depress quick-release button (1) fully.
b. Remove wheel by sliding axle out of

axle sleeve (2).

c. Repeat steps on other side.

1. Quick-Release Button

Figure A

M. MODIFIED SEAT SYSTEMS

Use of a seat system not approved by Sunrise may alter the center of balance of
this chair.This may cause the chair to tip over.
1. Do not change the seat system of your chair UNLESS you consult your

authorized supplier first.

2. Use of a seat system not approved by Sunrise may affect the folding mechanism

of this chair.

3. Use of a seating system not provided by Sunrise is prohibited for transit use.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

N. UPHOLSTERY FABRIC

1. Replace worn or torn fabric of seat and seat back as soon as you can. If you

fail to do so, the seat may fail.

2. Sling fabric will weaken with age and use. Look for fraying or thin spots, or

stretching of fabrics at rivet holes.

3. “Dropping down” into your chair will weaken fabric and result in the need to

inspect and replace the seat more often.

4. Be aware that laundering or excess moisture will reduce flame retardation of

the fabric.

If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.

V I I I .

W A R N I N G S :

C O M P O N E N T S & O P T I O N S

2. Axle

3. Axle Sleeve

Advertising