Saab 9-3 M03- - Manual (Page 12)

12 12 788 928
Saab 9-3 M03-
39 Locate the "Pre Acc" outlet between the engine
bay main fuse box and the front wing and
remove any adhesive tape or dummy connector.
40 Plug the wiring harness from the installation set
into the connector on the heater and route it
through the bulkhead space to the "Pre Acc"
outlet adjacent to the engine compartment elec-
trical centre.
41 Connect the ground cable to the front grounding
point (G30A) in the engine bay main fuse box.
42 Connect the wiring harness to the four pole "Pre
Acc" outlet.
43 Fasten the wiring harness with cable ties (x7).
Position the "Pre-Acc" outlet between the wiring
harness and the front wing.
44 Thread the fuel pump wiring harness down
alongside the fuel lines against the back edge of
the frame member.
Important
The wiring harness must be located in the seals by
the front wings.
Note
If the four pole "Pre Acc" outlet is already used,
connect into the existing connector as follows
– Unplug "Pre Acc"
– remove the seal from the connector on the
heater wiring harness and detach the cables
from the connector block
– fit the cables into the connector which was
plugged into "Pre-Acc", red cable (RD) in posi-
tion 1 and green cable (GN) in position 2
– Plug in the connector to "Pre Acc".
F920A019
41
42
42
43
43 43 43
40
43
Important
Check that the drainage hose at the filter is cor-
rectly fitted.