Saab 9-3 M03- - Manual (Page 14)

14 12 788 928
Saab 9-3 M03-
51 Position the fuel pump bracket up against the
vehicle floor, on the right-hand side in front of
the fuel tank, and drill holes using a 3.5 mm drill.
52 Deburr the holes and remove loose swarf and
paint particles. Clean with Teroson Cleaner FL
and apply Standox 1K primer. Apply a finishing
coat.
53 Fit the fuel pump with vibration damper and pro-
tective cover onto the bracket.
54 Connect the fuel lines to the fuel pump using a
joint hose and two hose clips for each connec-
tion. The joint hose which has a smaller diame-
ter at one end should be arranged so that this
end fits onto the smaller diameter connection of
the pump. Attach the long fuel line to the pump
bracket by threading a cable tie through the hole
in the bracket.
55 Connect the wiring harness to the fuel pump.
56 Attach the harness to the bracket using a cable
tie.
57 Screw the bracket with the pump assembly onto
the floor of the vehicle.
Important
The smaller diameter connection should point
towards the centre of the car and slightly forwards.
The protective cover should be positioned under
the pump.
F920A021
55
57
54
54
53
56
51