Sun Microsystems Sun Fire V40z - Manual (Page 58)

52 Sun Fire V20z and Stinger4 Servers Linux Operating System Installation Guide • May, 2004
4. Set up your DHCP configuration file (for example, /etc/dhcpd.conf ) so that
only PXEClient requests receive PXEClient responses.
Add the following entry to the DHCP configuration file. Refer to the dhcp.conf
man page for more information.
class "PXE" {match if substring(option vendor-class-identifier,
0, 9) ="PXEClient"; option vendor-class-identifier
"PXEClient";}
Note – You can start with a sample DHCP configuration file in
/tmp/sles8-pxefiles or /tmp/suse9-pxefiles directory.
5. For SUSE Linux Professional 9.0 only: Edit the /etc/sysconfig/dhcpd file and
be sure the DHCPD_INTERFACE is set to the interface that is connected to the
network you are planning to run the PXE server.
For example, if you are using Ethernet interface 0, the DHCPD_INTERFACE variable
would be set as follows:
DHCPD_INTERFACE="eth0"
6. Start the DHCP service by typing the following command:
# /etc/init.d/dhcpd start
7. Configure the server to always start DHCP by typing the following command:
# chkconfig dhcpd on
Installing Portmap
Complete the following steps on your DHCP server.
1. Determine whether the portmap server package is already installed on the server
by typing the following command:
# rpm -qa | grep portmap
2. If portmap is not listed, install the package using yast with the following
command:
# yast -i portmap