Samsung SRP-350 - Manual (Page 24)

46
First byte (printer information)
Bit Off/On Hex Decimal Status for ASB
0 Off 00 0 Not used. Fixed to Off.
1 Off 00 0 Not used. Fixed to Off.
Off 00 0 Drawer kick-out connector pin 3 is LOW.
2
On 04 4 Drawer kick-out connector pin 3 is HIGH.
Off 00 0 Online.
3
On 08 8 Offline.
4 On 10 16 Not used. Fixed to On.
Off 00 0 Cover is closed.
5
On 20 32 Cover is open.
Off 00 0 Paper is not being fed by using the PAPER FEED button.
6
On 40 64 Paper is being fed by using the PAPER FEED button.
7 Off 00 0 Not used. Fixed to Off.
Second byte (printer information)
Bit Off/On Hex Decimal Status for ASB
0 - - - Undefined.
1 - - - Undefined.
2 - - - Undefined.
Off 00 0 No Auto-cutter error.
3
On 08 8 Auto-cutter error occurred.
4 Off 00 00 Not used. Fixed to Off.
Off 00 0 No unrecoverable error.
5
On 20 32 Unrecoverable error occurred.
Off 00 0 No automatically recoverable error.
6
On 40 64 Automatically recoverable error occurred.
7 Off 00 0 Not used. Fixed to Off.
Bit 3 : If these errors occur due to paper jams or the line, it is possible to
recover by correcting the cause of the error and executing
DLE ENQ n (1≤n≤2). If an error due to a circuit failure
(e.g. wire break) occurs, it is impossible to recover.
Bit 6 : When printing is stopped due to high print head temperature until
the print head temperature drops sufficiently or when the paper roll
cover is open during printing, bit 6 is On.
47
Third byte (paper sensor information)
Bit Off/On Hex Decimal Status for ASB
Off 00 0 Paper roll Near-END sensor : paper adequate.
0,1
On 03 3 Paper roll Near-END sensor : paper near end.
Off 00 0 Paper roll end sensor : paper present.
2,3
On 0C 12 Paper roll end sensor : paper not present.
4 Off 00 0 Not used. Fixed Off.
5,6 - - - Undefined.
7 Off 00 0 Not used. Fixed Off.
Fourth byte (paper sensor information)
Bit Off/On Hex Decimal Status for ASB
0-3 - - - Undefined.
4 Off 00 0 Not used. Fixed Off.
5,6 - - - Undefined.
7 Off 00 0 Not used. Fixed Off.
[Default]
n=0 when DIP SW 2-1 is Off, n=2 when DIP SW 2-1 is On.
GS f n
[Name]
[Format]
[Range]
[Description] Select font for Human Readable Interpretation(HRI) characters.
ASCII GS f n
Hex 1D 66 n
Decimal 29 102 n
n = 0, 1, 48, 49
Selects a font for the HRI characters used when printing a bar code.
n selects a font from the following table :
n Font
0, 48 Font A (12 ×24)
1, 49 Font B (9 ×17)
GS h n
[Name]
[Format]
[Range]
[Description] Set bar code height.
ASCII GS f n
Hex 1D 68 n
Decimal 29 104 n
1 ≤ n ≤255
Set the height of the bar code.
n specifies the number of dots in the vertical direction.