Star Micronics LC-100+ - Manual (Page 12)

4 Printer Setup
Installing the platen knob
The platen knob is packed into a recess in the packaging material.
❏
Install the knob on the shaft located inside the large hole on the right side of
the printer. Make sure that the two splines of the platen shaft inside the
printer fit into the slots inside the knob’s spindle. Press the knob carefully
but firmly into place as far as it will go.
Opening the front cover
❏
Lift up on the front cover while pressing in gently on its sides.
❏
To close the front cover, simply lower it back into place.
Caution!
The tear assist edge is rather sharp. Take care to avoid injuring your hands.