Smeg CW400RSD User Manual
Page 13
12
Once the program has finished the message “END”
appears on the display. The
led indicator remains
red.
Basket removal
By closing the door the last executed program is proposed again and the
led indicator turns green
Note:
While the water in the boiler and in the Tank is heating up, the display may show the Tank resistance
and
boiler resistance
symbols.
8.3 PROGRAM
SELECTION
PROGRAM DURATION(*)
P1
Brief about 1’
P2
Medium about 2’ ( crystals cycle )
P3
Long about 3’
P4
Continuous from 0 to 10’
(*)The cycle durations indicated above are based upon a tri-phase connection with a 50°C hot water
supply.
Where a cold water supply is used, the duration of the cycle could increase in relation to the input water
temperature since the dishwasher is equipped with a constant temperature and pressure rinse system.
8.4 RESIN CYCLE (for models equipped with water-softeners)
Upon reaching the number of set cycles the message
“rig” appears flashing on the display for 10”; if a
subsequent cycle is performed, and the request is
ignored, the message reappears for 10” at the end of
every cycle.
When the machine is on with the Tank either full or
empty press the
button until the “rig” message
appears.
Open the door and remove the overflow. Close the
door again and hold down the
button to empty the
Tank and the boiler. The
drain led indicator will flash
until draining has been completed.
END