Sanyo CE52LH1R - Manual (Page 10)

10
This LCD monitor allows you to set up the following:
SETTING PROCEDURE
1 . Press and hold the GREEN button on the remote control for 4
seconds. (Installation Mode will appear)
2. Use the 5 or 6 button to highlight each option, use the 1 or
2 button to adjust each option. Press the MENU button to exit
the mode.
■ On Program
Select ON program using the 5 or 6 button, select the start up
position using the 1 or 2 buttons.
(Off/ AV1/ AV2/ AV3/ PC/ DVI)
■ Max Volume
Select Max volume using the 5 or 6 button, use the 1 or
2 buttons to set the maximum volume required.
■ Winter mode
This Function can be activated when the LCD monitor is used during
cold temperature conditions, approximately 38˚F/ 4˚C or below to
maintain picture performance.
Using the 5 or 6
button select winter mode, once highlighted
you can select ON or OFF by pressing the 1 or 2 button.
IMPORTANT: The AC cord should not be disconnected during the
operation of Winter mode function.
When in winter mode, power consumption is higher than normal
standby consumption. This is entirely due to the operation of heating
circuitry. We strongly recommend to turn off Winter mode when the
ambient temperature is above 38˚F/ 4˚C.
■ RC inhibition
You can prevent unwanted remote control operation by selecting RC
Inhibition.
Select using the 5 or 6
button. Press the 1 or 2 button
to select On or Off.
To re-instate RC operation press and hold the green button on the
remote control and select RC inhibition OFF.
■ Child Lock
You can prevent unwanted operation of the LCD monitor via the
buttons on the rear of the monitor.
Select using the 5 or 6
button. Press the 1 button to select
On or OFF.
■ Address
Set the address for the LCD monitor.
■ Baud rate
Select Baud rate using the 5 or 6 button. To set the
transmission speed for PJ-NET communication of 19200 or 9600
Baud rate by pressing the 1 or 2
button.
■ Panel Protect Rotation
Select Panel Protect Rotation using the 5 or 6 button, once
highlighted you can select ON or OFF by pressing the 1 or 2
button.
■ AV Auto shut off
Select AV Auto Shut Off using the 5 or 6 button, once
highlighted you can select On or Off by pressing the 1 or 2
button.
■ LED Light setting
Select LED Light setting usinig the 5 or 6 button, once
highlighted you can select On or Off by pressing the 1 or 2
button.
■ DCR
Select DCR usinig the 5 or 6 button, once highlighted you can
select On or Off by pressing the 1 or 2 button.
■ Main S/W Version
To record the version for Main Software.
■ Temperature Error
This function can record times for abnormal temperature.
■ IP Address / Subnet / Gateway / DNS
These 4 items display the PJ-Net information. If no PJ-NET had
been connected, all the items would be displayed “000000000000”.
✐ Disconnecting the mains supply before exiting Installation Mode
will cancel the following features On program, RC inhibition, Address
and Baud Rate.
INST INST ALLA ALLA TION MODE TION MODE GB GB
Installation Mode
Temperature Error
1.08
Installation Mode