Sony KP-53SV75A - Manual (Page 35)

– 35 –
KP-43T75A/53SV75A
RM-Y906 RM-Y906
TV
2
5
8
0
1
4
7
3
6
9
ENTER JUMP
GUIDE INDEX
RESET MENU
CODE SET
VOL CH
POWER MUTING
FREEZE
AUDIO
ANT TV/VIDEO
DISPLAY MTS/SAP CC PICTURE
MODE
POSITION ACTIVE
SWAP PIP TV/VTR
SYSTEM
OFF DVD/VTR SAT/CABLE TV
DVD/
VTR
SAT/
CABLE
FUNCTION
SLEEP
m N M
x z X
TV
3-10. REGISTRATION ADJUSTMENT (PJE)
• FUNCTION OF BUTTONS OF REMOTE
COMMANDER FOR PJE MODE.
Adjustment item
up
Adjustment item
down
Color select
GRNnBLUnRED
Test signal select
crosshach+video signal
dots+video signal
crosshach+black
dots+black
off
Mode select
Coarse adjustment
Fine adjustment
data up/down
[SETUP FOR ADJUSTMENT]
• Current flow in circuit should be stable before attempting
adjustment. So wait 5 minutes after turning on the TV power.
• At the 4 insides of the screen, locate the middle. Use a tape
measure to identify the middle.
( )
1. Set to the service mode by pressing quickly keys on the remote
commander in the standby mode in the following order:
[DISPLAY] n 5 n [VOL+] n [TV POWER]
2. Change TV mode to the video input mode.
3. Change the VPNT mode to the PJE 00 FDIS.
PJE 00 00
FDIS
4. Set FDIS data to “01” to display the registration data of each
spot in the fine adjustment.
PJE 00 01
FDIS
5. Press
6 to display the test signal (crosshatch) on the screen.
6. Select GRN CENT(*) with the
1 and 4 keys on the remote
commander and check that the adjustment data is now “000”
both vertically and horizontally.
GRN 000 000
CENT
(H) (V)
*: In the factory preset, “GRN CENT” appears on the screen first.
In case of other colors “RED” or “BLU”, change color by
every pressing
3 key.
7. Cover the both red and blue picture lenses with the lens caps to
show only the green color.
SUB DEFLECTION ADJUSTMENT ITEM
Adjustment O : Yes – : No
ENTER
INIT*
READ*
INIT*: Press 7, "INIT" green letters appear on the screen.
Then press ENTER, all the PJE data are reset.
READ*: Press 0, "READ" green letters appear on the screen.
Then press ENTER, all the PJE default data are
restored.
Note: Internal patterns are used for geometry and convergence
adjustments. However, sizing and centering must be done with
the use of an external generator. The recommended pattern
would be a monoscope, or equivalent pattern, which would
provide the means to adjust both the linearity and sizing of the
picture.
Adjustment type
Display Adjustment item G R B
H/V H/V H/V
CENT CENT O/O O/O O/O
SKEW SKEW O/O O/O O/O
SIZE SIZE –/– O/O O/O
LIN LIN –/– O/– O/–
KEY KEY –/– –/O –/O
PIN PIN –/O –/O –/O
: middle
• Separate adjustments are required for multiple modes and
should be done in the following order (as each mode requires a
separate adjustment) :
• NTSC mode
• PAL-N mode
In all these modes, both color convergence and geometry
adjustment affects each other.