Sakar 90379 - Manual (Page 18)

18
4. Press the or button to select the icon shown on the LCD screen.
Press the FLASH/SET button. The photo quality is now set to STANDARD.
Taking Photos
Hold the camera steadily and press the shutter button to take photo. The flash Indicator light will turn red and
there will be a short delay while the camera saves the photo to memory. First this icon will appear followed by
the “photo saved” and a beep. Do not move the camera until you see this icon.
The numbers of photos left to shoot is briefly displayed in large white numbers in the center of the LCD screen
when it returns to the icon mode, after each photo is shot. You will hear another beep which indicates that the
camera is ready to take another photo.
When the camera's memory -- photo capacity -- is full, the LCD MONITOR will display “0”. If you attempt to take
a photo when the memory is full the camera will “beep” continuously. The photo will not be stored once the
memory is full. You need to delete photos (either one or all) in order to take additional photos (see Delete Mode
later in this manual).
Setting The Flash
In low light conditions it is best to use the built-in flash. You can also use the flash to compensate for backlight
conditions.
To set the flash:
1. Please make sure that the camera is on.