Swann NIGHTHAWK 3-Feb - Manual (Page 2)

H General Installation Notes and Tips
1. Test the camera signal before permanently installing the cameras.
2. Using battery power is only recommended for testing purposes as the cameras do require constant power to operate.
3. IR or night vision will reflect off of glass or windows and overexpose the picture. Try placing cameras in direct line of
sight of your subject.
4. Never aim the camera directly at the sun as this can permanently damage the lens.
5. Never submerge the camera in water. Some shelter is recommended such as an awning or eave.
Camera Positioning
Achieving the highest quality signal G
G F E
Wireless Internet
Cordless Phones/Mobiles
Some Electronic Devices
If you are still receiving interference change the
camera’s channel as per step E then switch the
receiver to the correct channel If possible turn off or keep
the camera and receiver
away from wireless devices
Some wireless devices can
be set to different frequencies.
Consult the manufacturer’s
manual for details
A clear line of sight with little wireless
interference will always give you the
strongest picture
Walls and floors can also limit range and image results. Place the receiver in a location that
is relatively close to the camera’s position
Setting the Camera Channel
1. Find the seam running
around the middle of
the camera
2. Twist the front half of the
camera counter-clockwise
to remove the outer casing 3. Locate the small white
dip switches in the
upper left region of
the camera
4. Using your fingernail or pen,
move the dip switches up
or down to change to the
appropriate channel
Channel and Frequency Settings
Channel 1
2414MHz Channel 2
2432MHz
Channel 4
2468MHz Channel 3
2450MHz
1
2 1
2
1
2 1
2
Note: Wireless and electronic devices such as these can interfere with camera
transmission if they are within the cameras range.
Note: If your camera
has a hood, remove
the 2 screws first
Nighthawk 2/3 Camera Kit Easy Setup Guide
www.swannsecurity.com
6ZDQQ&RPPXQLFDWLRQV‡7ROO)UHH7HFKQLFDO6XSSRUW 86$1 877 274 3695, Australia - 1300 13 8324‡(PDLO [email protected]