Spectra KT2038 - Manual (Page 8)

To Emphasize the Bass Sound
Set the DBBS (BASS BOOST) switch to the ON position.
Note: The bass boost performance will be dependent on the VOLUME control
setting.
Turning Power on and off
This unit has no ON / OFF switch.
To turn ON and OFF, press the following buttons.
To turn ON: Press PLAY/PAUSE button (playback starts)
To turn OFF: Press STOP button once for standby mode.
Press STOP button again to turn off the power.
Auto power-off function
When the unit is stopped (standby mode) for approximately 30 sec, the power will
be automatically turned off.
To Remove the Disc
Hold the edge and gently press the center
pivot as illustrated, then pick up the disc.
Caution: Wait for the disc to stop
rotating before sliding the OPEN switch.
NOTE:
• This unit can play 3 inch (8cm) single CDs without an adaptor. Do not use a CD
single adaptor for these discs.
• This player plays not only commercial CDs but also self-compiled CD-R/RW
disc.
LCD DISPLAY INFORMATION
When the is pressed at initial start up
• The display will briefly display the information
of total tracks and playing time then proceed
to start playback
.
• To review the total number of tracks on the disc
and the total playing time, press the STOP
button once.
Note: The ESP buffer will fill automatically. If ESP
function is not required, press ESP button to switch it
off. Sound will be muted for 1 or 2 seconds
.
During PLAY mode
The track number and the elapsed playing time are
displayed.
8