Snapper ICFR7005BV - Manual (Page 3)

3
IMPORTANT SAFETY INSTRUCTIONS
OPERATIONAL PRECAUTIONS
(Continued From Previous Page)
6. Before removing debris or cleaning tines, repairing
or inspecting make certain engine, tines and all
moving parts have STOPPED. Disconnect and
secure spark plug wire away from plug to prevent
accidental starting.
7. Exercise CAUTION when changing directions while
operating tiller. DO NOT till in areas where stability or
traction is in doubt.
8. DO NOT overload the machine capacity by
attempting to till too deep at too fast a rate.
9. Be extra careful when tilling hard ground. Use less
tine engagement to maintain control of tiller.
10. Till only in daylight or in good artificial light.
11. Never operate tiller in wet areas. Always be sure of
your footing; keep a firm hold on the handle.
12. Do not operate on slopes
MAINTENANCE AND STORAGE
1. Keep all nuts, bolts, and screws tight and be sure
tiller is in safe operating condition.
2. Never store tiller with fuel in tank inside of a building
where fumes may reach an open flame or spark.
Allow engine to cool before storing in any enclosure.
3. To avoid fuel leakage and FIRE HAZARD, fuel must
be drained from tank before standing tiller on end.
Always keep engine free of spilled fuel, debris and
excessive grease.
4. Have your tiller inspected and serviced each year by
an authorized Snapper dealer. Determine if any
additional devices are available which might upgrade
the safety of your tiller.
5. Factory specified Snapper replacement parts must
be used to assure adequate protection against injury.