Snapper ICFR7005BV - Manual (Page 7)

7
Section 2 - OPERATING INSTRUCTIONS
2.3 STARTING – STOPPING
FIGURE 4
2.4 ENGINE STARTING PROCEDURE
Step 1: Place the WHEEL and TINE SHIFT LEVER in
the NEUTRAL position and make sure the WHEEL and
TINE CONTROL BAIL is in the released position.
Step 2: Briggs Engine - For cold starts, move the
CHOKE CONTROL on the engine forward into CHOKE
position. See Figure 5.
FIGURE 5
Step 2: Honda Engine - For cold starts, move the
ENGINE KILL SWITCH to the “ON” position. See Figure
5A. Move the CHOKE CONTROL on the engine
rearward into CHOKE position. See Figure 5B.
FIGURE 5A
FIGURE 5B
TO STOP
WHEEL & TINE
DRIVE RELEASE
WHEEL & TINE
CONTROL BAIL
PUSH FORWARD TO CHOKE
CHOKE
LEVER
MOVE THE ENGINE
KILL SWITCH TO “ON”
MOVE THE CHOKE
CONTROL TO THE
CHOKE POSITION