Sunbeam 1637 - Manual (Page 6)

 5
T
o
U
se
y
oUr
d
ryer
With the control setting switch in the “OFF” position, plug the Dryer into a standard
110-125-volt AC outlet. Select speed (airflow) setting that is most appropriate
to your needs and that will deliver the best results.
The control setting switch marked “OFF,” “LOW,” “HIGH” controls the airflow speed of
your Hair Dryer. Press up on the switch until it clicks into position “LOW” for LOW speed
or “HIGH” for HIGH speed.
When finished using your Dryer, move the control switch to the “OFF” position and
unplug the cord from the outlet.
a
ddiTional
i
nformaTion
cool shot button (Refer to Diagram)
When drying hair use a higher heat setting and switch to a lower heat setting when drying
is nearly complete. To finish, press the Cool Shot button. This will deactivate all heat flow
from the Dryer and blow cool air to lock in your hairstyle without causing over drying or
damage to your hair.
concentRatoR attachMent
Your Dryer comes equipped with an optional air concentrator attachment. Attach the
concentrator to the nozzle of your Dryer when you require extra airflow in certain areas.
Use to tighten a curl or wave or to loosen curly hair.
c
aUTion
Use your SUNbeAm ® Hospitality Hair Dryer with care. Directing a high volume of heat
continuously to one area can overheat hair and scalp. When using a HIGH heat setting,
hold the blower opening a few inches away from the hair, drying one section at a time.
Work layers of hair in quick strokes. Keep the dryer in motion until drying and styling
are complete.