Samsung SVR-440 - Manual (Page 40)

40
- MODE : Select one of four recording methods below.
CONTINUOUS Continuous recording mode for 24h for day
SCHEDULE Reserved recording
MOTION DETECT Recording is activated when the system detects the motion
from input video images.
SENSOR Recording is activated when the system detects the sensor
operation.
DISABLE This is a setup mode for not to be recorded
- IMAGE QUALITY[High/Mid/Low] : Set the compression level for images to be stored
- FRAME RATE : Set the recording frame rate. 30FPS is the maximum for FULL(720X480)
resolution and 120FPS is the maximum rate for QUAD(360X240) resolution.
- AUDIO : Select whether to save audio data along with video.
- POST REC TIME : Recording continues for the predefined hours since the occurrence of an
event. The available setting values are from 1 to 30 seconds.
- PRE RECORD : This is pre-event record setup. Automatically record 5 second of pre-event
data if you set 5 sec. Pre-event record is not activated if you set OFF.
- RELAY OUT : Set it ON to activate the relay output.
- EVENT BEEP : Set it YES to activate the Event beep when the occurrence of an event.
- SCHEDULE : Press ENT button when the cursor is on SCHEDULE, the schedule setup
screen appears as illustrated below.
Event buzzer will be applied to Ch1 ~ Ch4.
Schedule record can be set 24 hours per day. Press move to the right time
zone and select the desired record mode by using the ENT button.
C : Continuous recording
S : Sensor recording