Sun Microsystems 5945532 - Manual (Page 40)

22 Sun Dual 10GbE SFP+ PCIe ExpressModule User’s Guide • August 2008
4. Plug the Ethernet cable into the card port.
5. Power on the system.
6. Press the F2 key or the Control-E keys to go to the BIOS.
7. Check and ensure that the boot order of the network devices is higher than the
hard drive.
8. Press the F10 key to save the boot configuration changes and exit.
The system should reboot after saving the boot configuration.
9. Press the F12 key to install the OS from the network.
If the cable is connected to the correct port, you should see the MAC address that
you assigned to your PXE server displayed by BIOS.
10. Install the ixgbe driver and configure the Ethernet adapter.
11. After the Linux OS install completes, use the BIOS to change the boot device
priority to Boot from Hard Disk in order to boot up the newly installed OS.
Unless the boot device priority is changed, the OS installation process will repeat.
image : pxe-mac-addr
PXE-E61: Media test failure, check cable
PXE-MOF: Exiting Intel Boot Agent.
NVIDIA Boot Agent 217.0513
Copyright (C) 2001-2005) NVIDIA Corporation
Copyright (C) 1997-2000) NVIDIA Corporation
PXE-E61: Media test failure, check cable
PXE-MOF: Exiting Intel Boot Agent.
NVIDIA Boot Agent 217.0513
Copyright (C) 2001-2005) NVIDIA Corporation
Copyright (C) 1997-2000) NVIDIA Corporation
PXE-E61: Media test failure, check cable
PXE-MOF: Exiting Intel Boot Agent.
Intel (R) Boot Agent GE v1.2.43 Beta-1
Copyright (C) 1997-2006) Intel Corporation
CLIENT MAC ADDR; 00 15 17 13 90 00 GUID: 00000000 0000 0000 0000
00144F26E0B7