Skylink DIAL-ALERT AD-105 - Manual (Page 3)

All materials required for installation are included with this package
1 Dial-Alert (AD-105)
1 Telephone Line
1 antenna (installed)
1 AC adapter
1 9 volt alkaline battery
1 Pack of screws and anchors (for Dial-Alert)
One template
Double sided tape
User's instructions
Warranty Card
Quick Guide
– 4 –
PACKAGE CONTENTS
– 5 –
OVERVIEW
The AD-105 emergency dialer can call multiple phone numbers during an
emergency situation and it will playback prerecorded messages. There are 2
operating modes you can set up in the AD-105 dialer.
SC-001 Mode - Works with SC-001
You can setup the AD-105 to communicate with a control panel SC-001, so
when the SC-001 alarm is activated, it will send a panic signal to the dialer and
it will call you and other phone numbers (up to 9 phone numbers) and then
playback a 40-second pre-recorded message.
Sensor Mode - Works with multiple sensors directly
You can program sensors directly to the AD-105 so when any one of the
sensors is triggered, the dialer will dial the programmed phone numbers and
playback voice messages. It is possible to record one primary voice message
and up to 6 unique messages, these unique messages will be sensor specific.
905-608-9223
# *
…
AD-105
Sensor
Activation
Signal
Various
Sensor
A
B
C # *
905-608-9223
# *
SC-001 AD-105
Panic
Signal