Woodstock W1751 - Manual (Page 12)

-10-
W1751 25" Wide-Belt Sander
SE
T
U
P
The following is a description of the components
shipped with the Shop Fox W1751. Lay the components
out, and use Figure 2 and the list below to inventory
your package. If any parts are missing, find the part
number in the back of this manual and call Woodstock
International, Inc. at 360-734-3482 or e-mail:
[email protected].
Wide Belt Sander ..........................................1
Sanding Belt 100 Grit .....................................1
Sanding Belt 180 Grit .....................................1
Platen Assembly ............................................1
Crank Handle ...............................................1
Tool Box .....................................................1
—Phillips Head Screwdriver #2 ..........................1
—Open-End Wrench 8/10mm ............................ 1
—Open-End Wrench 12/14mm ..........................1
—Open-End Wrench 11/13mm ..........................1
—Open-End Wrench 17/19mm ..........................1
—Special Wrench ..........................................1
—10 Pc-Metric Hex Wrench Set .........................1
—Door Lever Keys .........................................2
—Platen Removal Tool ...................................1
Item Qty.
Unpacking
Box Contents
The Model W1751 has been carefully packaged for
safe transporting. If you notice the machine has been
damaged in shipment, contact your machine dealer and
the shipping company immediately.
SET UP
SUFFOCATION
HAZARD!
Immediately discard
all plastic bags and
packing materials to
eliminate choking/
suffocation hazards for
children and animals.
The Model W1751 weighs
approximately 1060 lbs.
Use power or hydraulic
equipment to avoid
serious personal injury
or death.
Figure 2. Parts and tool inventory.