Woodstock W1751 - Manual (Page 15)

-13-
W1751 25" Wide-Belt Sander
SE
T
U
P
Air Supply
1. Push the air supply hose onto the air pressure
regulator inlet fitting, and clamp it in place with a
hose clamp as shown in Figure 6.
Note: If you prefer, you can replace the included
air nozzle with a 3 ⁄
8
" male quick connect air
coupling.
2. When the air hose is installed, pull up and rotate
the regulator air pressure knob until the gauge reads
75 PSI, then push the knob down to lock in place.
DO NOT attempt to regulate the air pressure with
the ON/OFF air supply lever. This lever is the ON/
OFF air pressure to the machine only.
To achieve maximum life of the air system o-rings and
gaskets, keep the air pressure shut off when not using
the sander, and DO NOT exceed 75 PSI.
NOTICE
Figure 6. Air hose attached to regulator.
Figure 7. Dust collection hoses
attached to dust ports.
Ducting
Install two 5" dust collection hoses to the top of the
sander ( Figure 7).
Before performing any sanding operations, attach the
dust ports to a dust collector, which can draw at least
1250 CFM, or dust buildup will hinder the performance
of your sander.
Note: Even with a sufficient dust collection system, a
fine layer of dust may still be present on your stock
as it comes out of the sander. This residual dust is a
normal condition.
REMEMBER, this machine produces
fine sawdust particles that can be
inhaled, causing allergic reactions
or respiratory problems. ALWAYS
wear your respirator in addition to
using an adequate dust collection
system.