Sony SCD-XE597 - Manual (Page 12)

12 GB
Turning off the information in
the display
Press DISPLAY MODE on the remote.
Each time you press the button while playing a
disc, the display turns off and on alternately.
Even when the display is turned off, it will turn
on when certain buttons are pressed, and then
turn off again after a few seconds.
Before you start playing, when you press the
button to turn off the display, “DISP OFF”
appears, and when you press the button to turn
on the display, “DISP ON” appears.
Displaying the information of
a TEXT disc in other
languages
You can change the displayed language if the
TEXT disc has multi language capacity. When
the player detects such a TEXT disc, “MULTI-
TEXT” appears in the display. Change the
language according to the procedures below.
1
Press MENU on the player.
2
Turn l AMS L (or press ./>
on the remote repeatedly) until
“LANGUAGE” appears in the display.
3
Press l AMS L (or ENTER on the
remote).
The current selected language (ENGLISH,
FRENCH, GERMAN, etc.) flashes.
If the player cannot display the language
used in a TEXT disc, “OTHER LANG”
appears in the display.
4
Turn l AMS L (or press ./>
on the remote repeatedly) until the
desired language appears in the
display.
5
Press l AMS L (or ENTER on the
remote).
After a few seconds, the information
appears in the selected language.
You can locate a particular point in a track
during play or play pause.
Tip
When “OVER” appears in the display, the disc has
reached its end. Press and hold m to go back.
Note
Tracks that are only a few seconds long may be too
short for monitoring. In this case, the player may not
search correctly.
Locating a Particular
Point in a Track
Locating a point Do the following:
While monitoring the
sound (Search) Press and hold m/M
during play.
By observing the
time indication
(High-Speed Search) Press and hold m/M
during play pause.
By setting the start
time (Time Search) 1 Turn l AMS L (or
press ./> on the
remote repeatedly) in stop
mode to select the desired
track.
2 Press and hold m/M to
set the time to start play
while looking at the display,
then press H.