Sony SAT-B2 - Manual (Page 13)

Chapter 3: Connecting Your System 13
TV With A/V Connectors Refer to the illustration below (SAT-A2 receiver is pictured).
1
Connect the RG-6 cable from the satellite antenna’s LNB to the DSS
receiver’s SATELLITE IN jack.
If your TV has only one AUDIO IN jack,
connect the lower (mono) AUDIO L jack
on the DSS receiver to the TV’s AUDIO
IN jack.
2
Connect the DSS receiver’s A/V jacks to the TV’s A/V IN jacks.
3
Connect one end of the telephone line cord to the DSS receiver’s
TEL LINE jack. Connect the other end to your home’s modular
telephone outlet.
4
Connect one end of the AC power cord to the DSS receiver’s AC IN
jack. Connect the plug end to an AC outlet.
Optional Connections
Some TVs label this jack RF IN,
instead of VHF/UHF IN. If you have a cable input, cable box, or a terrestrial TV antenna,
connect it to the TV’s VHF/UHF IN jack.
Best Connection: If your TV has an S-VIDEO jack, use an S-VIDEO
cable to connect the DSS receiver’s S-VIDEO jack to the TV’s S-
VIDEO IN jack. This provides the best picture quality. Then use
audio cables to connect one set of the DSS receiver’s audio jacks to
the TV’s AUDIO IN jacks.
To connect the DSS receiver to your audio system, use audio cables
to connect the DSS receiver to your audio receiver’s AUDIO IN
jacks.
1 2 3 4
SAT-A2 receiver is pictured, but connections
are identical for SAT-B2.