Snapper 020230 - Manual (Page 7)

2650 PSI Pressure Washer
7
3. Insert one “L” hook through hole just above billboard
on left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten by hand.
4. Insert other “L” hook through hole just below
billboard on right side of handle (viewing from front of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten by hand.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine user’s manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine user’s manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 4).Tighten by hand.
2. Attach other end of high pressure hose to high
pressure outlet on pump (Figure 5).Tighten by hand.
CAUTION
• Refer to engine user’s manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
Figure 5 — Connect High Pressure Hose to Water Outlet
Hose Hook
Spray Gun Hook
Figure 3 — Attach “L” Hooks to Handle
Connect high
pressure hose here
Figure 4 — Connect High Pressure Hose to Spray Gun