Sony Ericsson TA-FA1200ES - Manual (Page 14)

14 GB
3
Press u to display “<2-Auto
Calibration>,” then press
ENTER to enter the menu.
4
Press u to display “CAL TYPE,”
then press ENTER to enter the
parameter.
5
Press U/u to select the
parameter, then press ENTER
to enter the selection.
6
Press U to display “AUTO CAL
START?,” then press ENTER to
start the measurement.
Measurement starts in five seconds. A
countdown appears on the display.
While the time is counting down, stand
away from the measurement area to
avoid measurement error.
7
Measurement starts.
The measurement process will take
approximately 10 seconds. Wait until the
measurement process completes.
Tip
When special speakers, such as dipole speakers, are
used, the measurements may not be performed
correctly or auto calibration cannot be performed.
To cancel auto calibration
Auto calibration is cancelled when you change
the volume, change the input source, change
the speaker selection, press MUTING, or
connect headphones.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2
Press U/u repeatedly to select
the item, then press ENTER.
When error codes appear
Try the remedies and re-perform the auto
calibration.
Calibration
type Explanation
ENGINEER Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
FULL FLAT Makes the measurement of
frequency from each
speaker flat.
Confirming/saving the
measurement results
Measurement
result Display Explanation
When the
measurement
process
completes
properly COMPLETE Proceed to step
2.
When the
measurement
process fails ERROR
CODE XX See “When
error codes
appear” (page
14).
Item Explanation
RETRY Re-performs the auto
calibration.
SAVE EXIT Saves the measurement
results and exits the setting
process.
WRN CHECK Displays a warning
concerning the
measurement results. See
“When you select “WRN
CHECK”” (page 15).
EXIT Exits the setting process
without saving the
measurement results.
Error code Cause and remedies
CODE 31 SPEAKERS (OFF/A/B/A+B) is
set to OFF. Select A or B and re-
perform the auto calibration.
When using a bi-amplifier
connection, set SPEAKERS
(OFF/A/B/A+B) to A+B.