Sunbeam 4817-8 - Manual (Page 4)

4
Assembling Your Oskar ® Food Processor
Using Clear Container and Cover:
Before you begin, PLEASE BE SURE THAT THE ELECTRIC CORD IS UNPLUGGED.
Set up the motor base facing you on a dry,
level surface with the tallest side of the
motor housing to the rear.
NOTE: Located on the top, back of the motor
base is an arrow and the words “LOCK-ON”
to the left and “UNLOCK-OFF” to the right.
Turn the clear bowl in the direction indicated
to turn the food processor ON or OFF.
Place the clear Processing Container over the
drive shaft on the motor base and rotate the
container until it drops down evenly on the base.
Now turn the Container until it locks firmly
into position.
NOTE: Each time you re-assemble your food
processor, be sure to attach the Container first
and lock it into position. Then, attach the Cover.
Place the cutting/processing blade over the drive
shaft, rotating it slightly until it drops into place.
If you plan to process with blade, now is the time
to add ingredients. THE BLADE IS EXTREMELY
SHARP. USE CAUTION HANDLING THIS BLADE.
To attach the cover, place the Cover on the
Container so that the large locking tab of the
cover is to the right-hand side near the
horizontal slot at the back of the motor base.
When turned counterclockwise, the tab will
engage the automatic switch and the OSKAR
®
Food Processor will turn ON. By moving the
cover in the opposite direction, it will turn OFF.
NOTE: The stainless steel cutting/processing blade
can only be used in the OSKAR
® Food Processor's
clear processing container for in-bowl chopping,
mixing or puréeing functions; NEVER with
continuous flow cover on top of the clear bowl.