SpectraLink 72-1065-01 - Manual (Page 8)

SpectraLink Corporation Quick Start Guide
NetLink Components
PN: 72-1065-01-B.doc Page 8
3. NetLink Component Setup Sequence
Generally, the installation and configuration process follows these steps.
1. WLAN Set up the LAN: A wireless LAN must be properly configured and
operational through the use of 802.11b wireless access points (APs). All NetLink
components must be on the same subnet. See the Polycom WLAN Compatibility
Table for APs that have been tested with NetLink Wireless Telephones. A TFTP
server must be present in a system that does not use SRP. The NetLink
Telephony Gateways functions as a TFTP server in SRP environments.
2. Access Point Configuration Access points (APs) are NOT configured from
the Administration Console. They are administered independently as covered in
the Access Point Configuration Guide for the specific type of access point in use.
3. Install NetLink Telephony Gateway Install the NetLink Telephony
Gateway(s) and the NetLink SVP Server(s), if required per document
instructions. This entails the physical placement of the devices and their related
equipment.
Install NetLink SVP Server Required for other IP protocols, required if five
or more NetLink Telephony Gateways are installed, optional if fewer than five
NetLink Telephony Gateways are installed.
4. Software Update: Ensure the most recent software is installed on the NetLink
Telephony Gateway and/or NetLink SVP Server. Download and install more
recent versions, if necessary. Downloads for NetLink components are available
from
http://www.polycom.com/usa/en/support/voice/wi-fi/wi-fi.html . Install
per document instructions for each component.
5. Software Update Download and install software for the NetLink Wireless
Telephones per document instructions. When each the handset is powered up
for the first time, it will automatically download this software over the air.
6. NetLink Telephony Gateway Configuration Configure the NetLink
Telephony Gateway(s) network parameters and the interface to the host
telephone system. Configure the ports for each of the 16 possible NetLink
Wireless Telephones associated with each NetLink Telephony Gateway.
NetLink SVP Server Configuration Configure the NetLink SVP Server(s)
network parameters per document instructions.
7. NetLink Wireless Telephone Configuration Program the Admin menu in
each NetLink Wireless Telephone and set end user preferences in the Standby
menu per document instructions. The NetLink Configuration Cradle may be
used for this process. See SpectraLink 8002, e340/h340/i640 Wireless Telephone
Configuration Cradle Administration Guide for complete instructions.
8. Site Certification Test and certify the site per document instructions located in
the SpectraLink Wireless Telephone Configuration and Administration document for
your system.