Standard Horizon PHANTOM Series PS2000 - Manual (Page 53)

Page 53 Phantom PS2000
12.8 SCAN TYPE
This selection selects the scan mode between “Memory Scan” and “Priority
Scan.”
1. Press and hold down the [CALL(SET)MENU] key until
“ RARIO SETUP ” menu appears.
2. Press the [CALL(SET)MENU] key, then press the [ ] or
[ ] key to select “ SCAN TYPE ” menu.
3. Press the [CALL(SET)MENU] key.
4. Press the [
] or [ ] key to select “ MEMORY ” or “ PRIOR-
ITY .”
5. Press the [CALL(SET)MENU] key to store the selected set-
ting.
6. Press the [16/9] key to return to radio operation.
12.9 SCAN RESUME TIME
This selection is used to select the time the PS2000 waits after a transmission
ends before starting scanning.
1. Press and hold down the [CALL(SET)MENU] key until
“ RARIO SETUP ” menu appears.
2. Press the [CALL(SET)MENU] key, then press the [ ] or
[ ] key to select “ SCAN RESUME ” menu.
3. Press the [CALL(SET)MENU] key.
4. Press the [
] or [ ] key to select the desired resume time.
The resume time can be set to “ 3 (3 seconds),” “ 2 (2 sec-
onds),” “ 1 (1 seconds),” or “ oF (off).” In the “ oF (off)” selec-
tion, the scanner will resume after the other station stops
transmitting (carrier drops).
5. Press the [CALL(SET)MENU] key to store the selected set-
ting.
6. Press the [16/9] key to return to radio operation.