Schlage F-Series - Manual (Page 3)

5
Install Inside Chassis
a. Align holes in inside chassis with holes in outside knob/lever.
FOR KEYED FUNCTIONS WITH LEVERS: Rotate chassis so lever catch
faces latch.
FOR ALL OTHER FUNCTIONS: Rotate chassis so knob/lever catch faces
away from latch.
b. FOR F51 Keyed Entrance ONLY: Rotate thumbturn until slot in chassis
is aligned with spindle.
c. Insert two (2) screws into holes in chassis and tighten.
Instalación de la perilla/manija interior
a. Alinear los agujeros de la chasis interior con los agujeros en la
perilla/manija exterior.
FOR KEYED FUNCTIONS WITH LEVERS: Rotate chassis so lever catch
faces latch.
FOR ALL OTHER FUNCTIONS: Rotate chassis so knob/lever catch faces
away from latch.
b. Para la entrada con llave tipo F51 SOLAMENTE: Rotar la guía hasta
que la ranura en la chasis quede alineada con el vástago.
c. Introducir dos (2) tornillos en los agujeros en la chasis y apretarlos.
Poser le bouton/levier intérieur
a. Aligner les trous du châssis intérieur avec les trous du bouton/levier
extérieur.
FOR KEYED FUNCTIONS WITH LEVERS: Rotate chassis so lever catch
faces latch.
FOR ALL OTHER FUNCTIONS: Rotate chassis so knob/lever catch faces
away from latch.
b. POUR l'entrée fermant à clé F51 UNIQUEMENT: Faire tourner le
tourniquet jusqu'à ce que la fente du châssis soit alignée avec la tige.
c. Insérer deux (2) vis dans les trous du châssis et les serrer.
Slot
Ranura
Fente
Alinear los agujeros
Aligner les trous
Align Holes
F51 Only F51 Solamente F51 Seulement
a
c
4
Remove Inside Knob/Lever and Rose/Escutcheon
a. Remove lever by pushing pin into hole and pulling lever off.
b.
Remove rose/escutcheon from chassis.
Spindle
Vástago
Tige
Turn Button
Botón giratorio
Bouton à tourner
b
6
Install Rose/Escutcheon and Knob/Lever
a. Snap rose into place OR place escutcheon over chassis.
b.
Slide lever onto spindle until it clicks into place.
Inside Chassis
Chasis interior
Châssis intérieur
Non-Keyed Functions
Non-Keyed Functions
Non-Keyed Functions
Keyed Functions
Keyed Functions
Keyed Functions
Push Pin
Pasador de empuje
Punaise
Remove Inside Knob/Lever and Rose/Escutcheon
a. Remove lever by pushing pin into hole and pulling lever off.
b.
Remove rose/escutcheon from chassis.
Remove Inside Knob/Lever and Rose/Escutcheon
a. Remove lever by pushing pin into hole and pulling lever off.
b.
Remove rose/escutcheon from chassis.
Install Rose/Escutcheon and Knob/Lever
a. Snap rose into place OR place escutcheon over chassis.
b.
Slide lever onto spindle until it clicks into place.
Install Rose/Escutcheon and Knob/Lever
a. Snap rose into place OR place escutcheon over chassis.
b.
Slide lever onto spindle until it clicks into place.
Escutcheon Trim
Escutcheon Trim
Escutcheon Trim
Lever Catch
Lever Catch
Lever Catch
Latch
Pestillo
Verrou