Southbend DMS-30 - Manual (Page 2)

1100 Old Honeycutt Road, Fuquay-Varina, NC 27526
(919) 762-1000 www.southbendnc.com
Models:
Form DMT Rev 1 (November/2010)
 DMT-30  DMT-40  DMT-60  DMS-30  DMS-40  DMS-60
INTENDED FOR COMMERCIAL USE ONLY.
NOT FOR HOUSEHOLD USE
.
M odel S hipping W eight M iniMuM C learanCe C apaCity u nitS a B C d e F g
DMT-30 475 lbs. [215 kg]
SIDES
BACK
0
0
30 Gallons
(114 liters)
inches
(mm)
24”
(610)
36”
(914)
16”
(406)
39”
(991)
37.25”
(946)
41.5”
(1054)
65.25”
(1657) DMS-30 375 lbs. [170 kg]
DMT-40 525 lbs. [238 kg] 40 Gallons
(151 liters)
inches
(mm)
26”
(660)
36”
(914)
15”
(381)
40”
(1016)
38.38”
(975)
42.5”
(1080)
68.25”
(1733) DMS-40 400 lbs. [181 kg]
DMT-60 600 lbs. [272 kg] 60 Gallons
(227 liters)
inches
(mm)
29.5”
(749)
42”
(1067)
16”
(406)
43”
(1092)
41.12”
(1045)
47.62”
(1210)
74.25”
(1886) DMS-60 500 lbs. [227 kg]
SERVICE CONNECTIONS
– COLD WATER: 3/8” O.D. tubing to faucet.
– HOT WATER: 3/8” O.D. tubing to faucet.
– DRAIN: 1-5/8” (41.275 mm) O.D. tubing piped to open floor drain. No solid connection.
– ELECTRICAL CONNECTION: (DMT models only) 1/2” conduit connection to controls. Unless otherwise
specified, field wire electrical connection to be 120V, 60 Hz, single Phase, 10 Amps with grounding wire.
– STEAM SUPPLY: 3/4” (19 mm) IPS for incoming steam. MIN 5PSI (34kPa), MAX 35 PSI (241 kPa).
Important: Pressure reducing valve required if incoming steam pressure exceeds the kettle rating.
DIMENSIONS