Assembly – Stanley Black & Decker 387002x92NA User Manual

Page 13

Advertising
background image

ASSEMBLY

13

F–040700C

IMPORTANT! BEFORE YOU START MOWING

- Check the engine oil.
- Fill the fuel tank with gasoline.
- Check the level of the mower housing.
- Check the air pressure of the tires.
- Make sure the battery cables are attached.

WARNING: Before doing any assembly or mainte-

nance to the mower, remove the wire from the spark

plug.

NOTE: In this instruction book, left and right describe the loca-

tion of a part with the operator on the seat.

HOW TO PREPARE THE ENGINE

NOTE: The engine was shipped from the factory filled with oil.

Check the level of the oil. Add oil as needed.
See the engine manufacturer’s instructions for the type of gasoline

and oil to use. Before you use the unit, read the information on

safety, operation, maintenance, and storage.

WARNING: Follow the engine manufacturer’s

instructions for the type of gasoline and oil to use.

Always use a safety gasoline container. Do not

smoke when adding gasoline to the engine. When

inside an enclosure, do not fill with gasoline. Before

you add gasoline, stop the engine. Let the engine

cool for several minutes.

NOTE: Actual sustained horsepower will likely be lower due to

operating limitations and environmental factors.

IMPORTANT: This unit is equipped with an internal combustion

engine and must not be used on or near any unimproved

forest–covered, brush–covered or grass–covered land unless

the engine’s exhaust system is equipped with a spark arrester

meeting applicable local or state laws (if any). If a spark

arrester is used, it must be maintained in effective working

order by the operator.

In the State of California the above is required by law (Section

4442 of the California Public Resources Code). Other states

may have similar laws. Federal laws apply on federal lands.

See an Authorized Service Center for a spark arrester for the

muffler.

In some areas, local law requires the use of a resistor spark

plug to control the ignition signals. See an Authorized Service

Center for a resistor spark plug for the engine.

CHECK THE LEVEL OF THE MOWER HOUSING

Make sure the level of cut is still correct. After you mow a short

distance, look at the area that was cut. If the mower housing does

not cut level, see the instructions on “How To Level The Mower

Housing” in the Maintenance section of this instruction book.

CHECK THE TIRES

Check the air pressure in the tires. Tires with too much air pressure

will cause the unit to ride rough. Also, the wrong air pressure will

keep the mower housing from cutting level. The correct air pressure

(PSI) is 14 PSI (1 BAR). The tires were over inflated for shipment.

Advertising