Stanley Black & Decker 387002x92NA - Manual (Page 29)

MAINTENANCE
29 F–040700C
HOW TO REPLACE THE MOWER DRIVE BELT
1. Remove the mower housing. See the instructions on “How To
Remove The Mower Housing”.
2. Pull the belt retainer away from the idler pulley and remove
the mower drive belt (Figure 28).
3. Pull the belt retainer away from the right mandrel pulley and
remove the mower drive belt.
4. Remove the mower drive belt from the left mandrel pulley.
NOTE: Replace the mower drive belt with an original
equipment belt from an authorized service center.
5. Install the new mower drive belt. Pull the belt retainer away
from the right mandrel pulley. Put the belt around the right
mandrel pulley.
6. Pull the belt retainer away from the idler pulley. Put the flat
side of the mower drive belt around the idler pulley.
7. Put the belt around the left mandrel pulley.
8. Make sure the “V” side of the mower drive belt is against the
mandrel pulleys as shown.
9. Make sure the mower drive belt is under the end of the cross
link rod as shown.
10. Make sure the mower drive belt is inside all the belt guides.
11. Install the mower housing. See the instructions on “How To In-
stall The Mower Housing”.
12. Before you mow, check the blade rotation control. See the in-
structions on “How To Adjust The Blade Rotation Control”.
Belt Retainer
Right Mandrel Pulley
Cross Link Rod
Belt
Retainer
Belt Guide Left Mandrel Pulley
Mower
Drive Belt
Idler Pulley
Belt Guide
Belt Guide
Figure 28