Samsung H1255A - Manual (Page 13)

SAMSUNG Washing Machine Owner’s Instructions 11
Washing a Load of Laundry
When the cycle is finished:
After the total cycle has finished, the power will turn off automatically.
1. Open the door.
Note: The door will not open untill the machine stops or the power turns off.
2. Remove laundry.
Washing clothes manually
You can wash clothes manually without using the Fuzzy Logic feature. To do so:
1. Turn the water supply on.
2. Press the Power button on the washing machine.
3. Open the door.
4. Load the articles one at a time loosely into the drum, without overfilling.
5. Close the door.
6. Put the detergent and, if necessary, softener or prewash detergent, in the appropriate
compartments.
7. Press the Temperature button to select the temperature
(cold water, 30˚C, 40˚C, 60˚C, 75˚C, 95˚C)
8. Press to rinse button to select the required number of rinse cycles.
Maximum number of rinse cycles is six.
The washing duration will be prolonged accordingly.
9. Press the Spin button to select the spin speed.
10. Press the Delay Start button repeatedly to cycle through the available delayed start
options (up to 24 hours mximum in one hour increments.). Displayed hours means
the time of ifinished washing-cycle.
11. Press the Start/Pause button and the machine will begin the cycle.
Using delay start
You can set the washing machine to finish your wash automatically at a later time, choosing
up to 24 hours mximum (in one hour increments). Displayed hours means the time of
finished washing-cycle.
To do this:
1. Manually or automatically set your washing machine for the type of clothes you are
washing.
2. Press the Delay Start button repeatedly until the delay time is set.
3. Press the Start/Pause button. The Delay Start indicator will light, and the clock will
begin counting down until it reaches your finish time.
4. To cancel Delay Start, press the Power button, then turn the washing machine on
again.
To Add Laundry ( )
1. Press the [Add Laundry] button.
• The washing machine will automatically pause to operate.
2. Wait about 30 seconds and check the [Add Laundry] button for the lamp state.
• On: you can add the laundry into the machine.
• Blinking: the machine drains water down to the safety level so it can get an additional
quantity of laundry (displayed in pause mode)
• Off: adding the laundry is not possible.
 The washing machine detects the internal quantity of laundry about 30 seconds before
deciding whether it could get more laundry.
3. Add the laundry.
4. Press the [Start / Pause] Button.
• Avoid adding the laundry when the machine has foamed up or is filled with water.
Otherwise, the foam or water may leak out of the door. So check it first before
opening the door.
H1255A-02263A_UK-0927.indd 11 2005-09-27 ¿ААь 9:49:16