Sanyo LC-2430 - Manual (Page 20)

Ringer volume
In the standby mode, press CALL REVIEW/
VOLUME or on the handset to set
the handset ringer volume.
The phone has two ringer tones, each with
two volume levels.
Earpiece volume/handset speaker volume
Pressing CALL REVIEW/VOLUME or
during a telephone call will change the earpiece
volume/handset speaker volume. This setting will
remain in effect even after you hang up the
telephone.
When you press in Loud mode or press
in Normal mode, a beep sounds.
Base ringer switch
This switch sets the base ringer HI, LOW, or OFF.
Base speaker volume control
To control the speaker volume of the base,
adjust the
VOLUME slide switch as desired.
Ringer A High
Ringer A Low
Ringer B High
Ringer B Low
<High>
<Medium>
<Loud>
<Normal>
Scanning
Lighted keypad
Adjusting the ringer and speaker volume
BASICS
Your phone automatically selects the clearest possible channel every time you
receive or place a call. Should you wish to switch channels during a call, the handset
provides a
DELETE/SCAN button.
The dialing keypad and the TALK/END key on the handset light up when you press
any key on the keypad. The light turns off if no key is pressed for 5 seconds.
E16
RING VOL
OFF–LOW-HI
VOLUME
CLT2430 5th 8/9 8/10/00 4:29 PM Page 20