Synopsys 640-pin Generic Device Adapter - Manual (Page 21)

November 2001 Synopsys, Inc. 21
The ModelSource 640-pin Adapter Chapter 3: Connecting the Daughterboard
Procedures
Caution
Do not connect or disconnect the Daughterboard to or from the Adapter
while the Adapter is mounted on the ModelSource modeling systems.
To connect the Daughterboard to the Adapter, follow these steps:
1. Remove the lid from the Adapter.
2. Set the Daughterboard on the Adapter, engaging the guide pins through the guide
pin holes.
3. Push firmly to seat.
4. Hand-tighten each of the Southco retractable screw fasteners.
5. Replace the Adapter lid.
To disconnect the Daughterboard from the Adapter, follow these steps:
1. Remove the lid from the Adapter.
2. Loosen the Southco retractable screw fasteners.
3. Push the ejectors on the Adapter.
4. Carefully lift the Daughterboard from the Adapter.
5. Replace the Adapter lid.