Synopsys 640-pin Generic Device Adapter - Manual (Page 26)

26 Synopsys, Inc. November 2001
Chapter 5: Completing the Model The ModelSource 640-pin Adapter
Labeling the Daughterboard
After you have completed the Shell Software and mounted the Adapter and
Daughterboard onto the ModelSource modeling systems, you must verify the
Daughterboard’s label and update it if necessary.
Note
Ensure that the Daughterboard is seated on the Adapter before you verify
and update the label. If the daughterboard is not seated, the software will
report the label as “GEN640”, the label of the Adapter itself.
If it is necessary to update the Daughterboard’s label, use the lm Label Device Adapter
utility to change the adapter’s label to the device_name used in the model’s Shell
Software. For more details, refer to “Label Device Adapter“ in the
ModelSource User’s
Manual .
Verifying the Model
After you have developed the model, you must verify it. For more information, see the
ModelSource User’s Manual and the Logic Model Development Manual .
Note
The pattern memory available for simulation is limited to the smallest
amount of available memory on any one of the eight modeling boards in the
four modelers.