Standard Horizon MAX CPF180I - Manual (Page 54)

Page 56 CPF180i and CPF300i
Language : Allows setting the language to display chart information. The language is chosen among the list
of languages available on the cartographic data (data cartridge or embedded charts).
Mode : Defines how objects are translated. Selections are:
Off : Enables the language chosen in the Language menu above. If the selected
language is not present on the objects information, English is used.
English : Always uses English.
Local : Uses the Local language present on C-MAP B
Y
J
EPPESEN
C-CARD. If no Local
language is available, English is used.
4. After the selection is made, press [CLR] repeatedly or move the ShuttlePoint knob to
the left repeatedly until the Chart page is shown.
NOTE
a. When the Chart Language is changed, the following settings are automatically selected: MODE
is set to Off and Chart Language is set to your selection.
b. If the C-CARD is removed or changed, the Chart Language should be confirmed and changed
if necessary.
6.0.8 Pictures & Diagrams
Using optional C-MAP B
Y
J
EPPESEN
MAX data cards allows you to show pictures or diagrams
on the CPF180i and CPF300i display. These Pictures are typically used to facilitate the
identification of cartographic objects or places around the map: they can be the landscape
layout nearby a harbour, the shape of a bridge or of a buoy etc. On some objects, such as
bridges, the image associated can represent the Diagram representing the shape of the
objects and the various characteristics (length, height, type of bridge etc.).
Figure 6.0.8 - Pictures and Diagrams
How to show the pictures or diagrams of a Multimedia Object
They are shown on the chart page with the camera icon
Move the cursor over the camera icon. You will get the quick info on the object and there
will be the camera icon on the top bar of the window:
Figure 6.0.8a - Example of Quick Info on MULTIMEDIA object
Press [I
MAGE
] on the CPF300i or press [ENT] for 1 second on the CPF180i to display the
image on the screen; press [E
XPAND
] on the CPF300i or press [ENT] on the CPF180i to
open the Full info on the object: