Sony RM-LG112 User Manual
Remote commander, Rm-lg112
Advertising
Table of contents
Document Outline
- Precautions
- Before you use your remote
- Inserting batteries into the remote
- Tip
- Notes
- Notes
- Note
- 1 Press AV ?/1 while holding down USE MODE.
- 2 Move the easy scroll key to select the input you want to control, then press the key to enter t...
- 3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code ...
- 4 Press ENTER.
- 5 Repeat steps 1 to 4 to control other components.
- To cancel programming
- To use the programmed input
- If programming is unsuccessful, check the following:
- To clear the memory of the remote
- Inserting batteries into the remote
- The numeric codes corresponding to the component and the maker of the component
- Setting remote control codes that are not stored in the remote
- 1 Press TV ?/1 while holding down USE MODE.
- 2 Move the easy scroll key to select the input you want to learn commands for, then press the key...
- 3 Press the button you want to use for the Learning function.
- 4 Point the remote control code receiver section of the remote towards the receiver/transmitter o...
- 5-10 cm
- 5 Press the appropriate button on the remote control to be learned to send the remote button code.
- Notes
- To cancel learning
- To clear the learned codes
- To use the learned input
- To use a command that has been learned
- To clear the memory of the remote
- Setting the sequence of IR codes
- 1 Press TV ?/1 while holding down USE MODE.
- 2 Move the easy scroll key to select “M1” or “M2”, then press the key to enter the selection.
- 3 Press the numeric buttons to select the macro step number.
- 4 Point the remote control code receiver section of the remote towards the receiver/transmitter o...
- 5 Press the appropriate button on the remote control to be learned to send the remote button code.
- 6 Repeat steps 1 through 5 to program up to 10 IR codes.
- Tip
- To cancel programming
- To delay the output of an IR code
- To clear the programmed IR codes
- To start macro play