Sony RM-LG112 - Manual (Page 9)

masterpage:Right
filename[\\B-02w2000e\SONY RM-LG112\4247243111\424724311RMLG112U\GB04ADV_RM-
LG112-U.fm]
9 GB
model name1[RM-LG112]
[4-247-243-11(1)]
Ad
v
a
nced Re
mote
Ope
rations
This chapter describes how to change the factory
setting of the easy scroll key and how to set the
remote to control non-Sony components.
You can program the remote to control non-
Sony components. Once the control signals have
been memorized, you can use those components
as part of your system.
Furthermore, you can also program the remote
for Sony components that the remote is unable to
control. Note that the remote can only control
components that accept infrared wireless control
signals.
Note
You cannot program “SOURCE”.
1
Press AV ?/1 while holding down USE
MODE .
The USE MODE button lights and “IR
SET” appears in the display.
2
Move the easy scroll key to select the
input you want to control, then press
the key to enter the selection.
For example, if you are going to control a
CD player, select CD/SACD.
You can also select the TV ?/1 button.
3
Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables starting from page 10 for
information on the numeric code(s)
corresponding to the component and the
maker of the component. (The first digit and
the last two digits of the numeric code
correspond to the category and the maker’s
code respectively.)
4
Press ENTER.
Once the numeric code has been verified,
the USE MODE button slowly flashes
twice and the remote automatically exits the
programming mode.
5
Repeat steps 1 to 4 to control other
components.
To cancel programming
Press USE MODE during any step. The remote
automatically exits the programming mode.
To use the programmed input
Move the easy scroll key to select the
programmed input, then press the key to enter
the selection.
If programming is unsuccessful,
check the following:
• If the USE MODE button does not light up in step
1, the batteries are weak. Replace both batteries.
• If the USE MODE button flashes 4 times in quick
succession while entering the numeric code, an error
has occurred. Start again from step 1.
• In step 1, the remote automatically exits the
programming mode if 60 seconds has passed after
pressing USE MODE. Start again from step 1.
Notes
• The USE MODE button turns off while a valid
button is pressed.
• In step 2, if you press the easy scroll key several
times, only the last selected input is valid.
• In step 2, if you press TV ?/1, only TV VOL +/–,
TV CH +/–, TV/VIDEO and WIDE buttons are
reprogrammed.
• In step 3, if you press the easy scroll key, the new
input is selected and the programming procedure
returns to the beginning of step 3.
• For the numeric codes, only the first three numbers
entered are valid.
To clear the memory of the
remote
Press ?/1, AV ?/1 and MASTER VOL – at the
same time. The USE MODE button flashes 3
times, then goes off.
Advanced Remote Operations
Programming the remote
continued