Stanton Complete DJ System DJLab 2.1 - Manual (Page 5)

M.212 CONTROL OVERVIEW REAR PANEL
5
16. Power Switch - Turns unit off and on.
17. Power Connector - Plug in the included power supply here.
18. Fader Start Control Jacks - Connect these jacks to the Fader input jacks of the CD player using the 3.5mm stereo mini cord.
19. Master Output - Unbalanced RCA connectors controlled by the Master level.
20. Line Inputs - Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, HiFi VCRs, cassette decks, DAT
machines, laser discs, tuners, even synthesizers or other mixing consoles. Note: Plug mono audio sources into both Left and Right inputs using
a "Y" cable connector.
21. Phono Inputs - Plug your turntables in here. When these connectors are used, your signal is fed directly to the high-quality RIAA phono
pre-amplifiers. Use this position only for turntables. Line level sources will overload the sensitive phono preamps and will cause distortion.
22. GND - Connect each of your turntable ground leads to either of the two ground terminals.