Stanton Complete DJ System DJLab 2.1 - Manual (Page 6)

Review this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and processors. Next, connect your
microphone and monitor headphones. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. Plug your mixer
into AC power. Now you are ready to switch everything on.
IMPORTANT: Always switch on your audio input sources , such as turntables or CD players first, then your mixer, and finally any amplifiers. When turning off,
always reverse this operation by turning off amplifiers, then your mixer, and then input devices.
Turntable
Power
Supply
CD Player Controller
DAT, etc.
Turntable
Power Amp.
M.212 QUICK SETUP DIAGRAM
6