SMC Networks TigerSwitch 100 - Manual (Page 291)

IGMP S
NOOPING
C
OMMANDS
3-147
ip igmp snooping router-port-expire-time
Use this command to configure the snooping router-port-expire-time. Use
the no form of this command to restore the default.
Syntax
ip igmp snooping router-port-expire-time seconds
no ip igmp snooping router-port-expire-time
seconds - The time the switch waits after the previous querier stops
before it considers the router port (i.e., the interface which had
been receiving query packets) to have expired.
(Range: 300-500)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must be using IGMPv2 for this command to take effect.
Example
The following shows how to configure the default timeout to 300 seconds:
Related Commands
ip igmp snooping version (3-141)
Console(config)#ip igmp snooping query-time-out 300
Console(config)#