Sennheiser EM 3732 - Manual (Page 82)

34
The operating menu
Starting the scan
Scan new Via the “ Scan new ” menu, you can scan all frequency banks for free
channels. The last scan result is overwritten.
̈ Before starting the scan, switch all transmitters of your system off ,
since channels used by switched-on transmitters will not be displayed
as “free channels”.
̈
Turn the jog dial 7 until the arrow points to “ Scan new ”.
̈
Press the jog dial 7 to start the scan.
The receiver scans the frequency banks one after the other for free
channels. This can take several minutes. After the scan, a table displays
the number of free channels for each frequency bank and the green
backlighting of the
save button 8 flashes.
Note:
You can cancel the scan at any time by pressing the esc button 6 . The
display changes to the setting mode of the “ Scan ” menu and the last
scan result is restored.
̈
Turn the jog dial 7 to select a frequency bank with a sufficient number
of free channels.
̈
Press the save button 8 .
The selected frequency bank is automatically called up in the “ B.Ch ”
menu.
̈
Select a channel from this frequency bank (see “Selecting a frequency
bank and a channel” on page 28).
Note:
After the scan, the channels that are occupied or subject to interference
are marked with a warning triangle and the text “
Freq. occupied ” in the
“ Tune ” menu.
Channel list
Scan new
Scan reset
esc
s ave
syn c
digital audio
processing
syn c
DEV M H z
790.800
03.03 BANK
CH
COM AF
B.Ch
1 . 790.800
MHz
Freq. occupied
EM3732_516551_0108_Sp6.book Seite 34 Dienstag, 18. Dezember 2007 11:55 11