I cannot start a hotsync, Operation when pressing the, Hotsync button of the cradle – Sony CLIE PEG-TG50 User Manual
Page 19: I cannot stop a hotsync, Operation, It takes a long time to complete a hotsync, Performing initial checks
19
I ca
nnot pe
rf
orm a
H
o
tS
y
n
c
®
ope
ra
ti
on
For particular problems about HotSync
®
operations, refer to
the following.
B Quit applications other than the Palm™ Desktop for CLIÉ software.
If you cannot perform the HotSync
®
operation even after following the
above instructions, perform a soft reset by pressing the reset button of your
CLIÉ handheld.
b
For details, refer to “Basic operations of your Sony CLIÉ™ handheld: Restarting
your Sony CLIÉ handheld” in the “Read This First (Operating Instructions).”
I cannot start a HotSync
®
operation when pressing the
HotSync button of the cradle
B Tap HotSync and check that Local and Cradle/Cable are selected.
B Perform a soft reset on your CLIÉ handheld.
I cannot stop a HotSync
®
operation
B You may not be able to stop a HotSync
®
operation by tapping Cancel for
a few seconds after you start a USB HotSync
®
operation. Try again after a
while.
B If you cannot stop a HotSync
®
operation even by tapping Cancel, perform
a soft reset on your CLIÉ handheld.
b
For details, refer to “Basic operations of your Sony CLIÉ™ handheld:
Restarting your Sony CLIÉ handheld” in the “Read This First (Operating
Instructions).”
It takes a long time to complete a HotSync
®
operation
B Depending on the application you are using, it may take time to complete
a HotSync
®
operation if the data/file is too large.
Performing initial checks
Continued on next page
• • • • • • • • • • • • • • • • • • • • • • • • •